Random good picture Not show

1 Fora tank with a cooling jacket or coils , liquid vaporization as a result of the loss of coolant flow must be considered.

2 Heating form: indirect heating with steam in taper cooling jacket inter layer.

3 If an external cooling jacket is used, the requirement on valve material can be further reduced.

4 Secondly, two dimensional conductive model of cooling jacket was set up and numerical simulation was carried out using one dimensional results. Temperature field in cooling jacket was computed.

5 The top of the mixing crock is provided with an inlet of sugar materials, a gas entrance, and a pressure gauge, and the outer wall of the mixing crock is provided with a water cooling jacket.

6 The result shows that this method is not only suitable to correct the calculation of heat, but also suitable to design the cooling jacket.

7 Another work of this thesis is numerical simulation of overlapped guide - plate stability for helium sub - cooling jacket.

8 For dirty water or sanitary sewage applications, clogging of the cooling jacket passages can easily occur due to a build-up of solids, grease,(www.Sentencedict.com) corrosion and other matter.

9 These designs utilize an internal by-pass system to circulate the pumped liquid throughout the motor cooling jacket.

10 Each tank is installed a sole heating jacket or cooling jacket. The material we all use the Miller plate.

11 These designs utilize an internal - pass system to circulate the pumped liquid throughout the motor cooling jacket.